How to Install House Siding
- by siteadmin
The first step in any siding project is to prepare the wall surface. This includes framing repairs, and installing water-resistant trim.
Calculate the area by measuring the length and height of each wall, noting any gables or roof dormers. Then cut J-channel strips using this data.
Most siding jobs require measuring and attaching trim pieces to walls. To begin a job correctly, you should first lay out the layout of your wall using levels or chalk lines. Then, start at the point where the exterior counter meets the foundation.
Before installing siding panels, you must install and secure J-channels on all windows and doors. They should be placed at each corner of the window or door, and overlap onto rows above. This allows any water that enters your siding through weepholes to run off without rotting or causing mold growth. For a seamless and attractive appearance, corners should also be plumb. They should align with the vertical lines on the wall.
Sheathing is required before siding can be installed. Sheathing is used to create a flat surface on which siding can adhere. It also acts as an insulation barrier or moisture barrier. Depending on which type of siding is chosen, flashing might also be required to divert rainwater away from corners and areas around windows and doors.
Sheathing materials can include plywood, OSB panels or gypsum. Fiberboard is also a good choice. Some contractors choose insulated sheathing for its additional insulation properties, while others prefer to keep walls as close as possible to the studs for structural integrity.
It is important to clean and remove old or damaged siding before sheathing. You can use a ladder, scaffolding or pressure washer to reach high points. Make sure the sheathing is straight, or use a storypole to prevent siding slivers from appearing above or beneath doors and windows.
Scaffolding and pump jack systems are an efficient way to work on multiple walls at once. These systems are available at most tool rental depots and are a safer alternative to ladders when working on walls.
Stagger your siding seams from the backwards to the forwards to avoid gaps and achieve an aesthetically pleasing outcome. Install J channels to cover the cut edges of soffit or fascia lengths at windows and doors for additional concealment.
Install and nail the first row siding so that the bottom lip hooks underneath the starter strip. Nail each piece at 16 inches apart, centered in their slots. This will allow for expansion and contraction. As needed, you can overlap each length by an inch or, if you are approaching from the window on your right side from left to right.
It is important to clean up after the installation to make the siding look its best. Sweep, dust and power wash your house before trimming shrubbery and making any cosmetic repairs. This will enhance curb appeal and its visual appeal. This will give your new siding the best possible appearance and enhance curb appeal.
Modern vinyl siding products are engineered to mimic the look of bricks, rocks or stone surfaces. Installation is much easier than with bricks or stones, and foundations or footings are not required.
When working on vinyl siding, a stable ladder or scaffolding will be necessary. Additional hands may also prove useful when handling long vinyl pieces. It would also be beneficial to remove any light fixtures, gutters, downspouts or other items that were on the house before installation. This will make the installation process easier for both contractor and homeowner.
The first step in any siding project is to prepare the wall surface. This includes framing repairs, and installing water-resistant trim. Calculate the area by measuring the length and height of each wall, noting any gables or roof dormers. Then cut J-channel strips using this data. Layout Most siding jobs require measuring and attaching trim…